I am trying to set up a salami / prosciutto fridge at home. This is good for everybody haha.FYISalami needs certain parameters to correctly culture and age.Day1 22-24C 95% Humidity Day2 18-20C 90% Humidity Day3 16-18C 85% Humidity Day4 14-16C 80% Humidity Day5 12-14C 80% HumidityDay6 12-14C 75% Humidity Day7 10-12C 75% Humidity To Age 10-12C 75% Humidity I have-a domestic fridge which I have cut and fitted an exhaust fan in the front a humidifier a light globe (for warming) a grey electrical box – holes cut and 4 single power points fitted.a Lcd display and control board (from Jaycar) for the arduinowhat it needs to do is the following I want the control panel to have, temp control, humidity control, I want the exhaust fan to run 1min every 4 hours – this is because ammonia builds up as a gas in the chamber, this needs to be removed via the attached fanI want the humidifier, the light and the fridge to be controlled by the same “temp” control; Ie Day1I set the fridge to 95% humidity and 24CLight on to temp then off - or on/off as needed Humidifier on to correct parameters then off - or on/off as neededExhaust fan comes on and the computer compensates this evacuation and temp/humidity is onDay2I set the fridge to 90% humidity and 22CLight on to temp (or fridge cooling, depending on temp)Humidifier on to correct parameters Exhaust fan comes on and the computer compensates this evacuation and temp/humidity is onEtc.. etc..etcNow this also means this needs to be adjustable via the little control box because some thicker sausage takes longer and thinner less… ie Humidity1=95%H 2=90%H 3=85%H 4=80%H 5=75%Htemp1=24C 2=22C 3=20C 4=18C 5=16C 6=14C 7=12C 8=10CAnddddd prosciutto doesn’t need this type temp/humidity drop. It only needs a stable 75% humidity and 12CThe idea is Ill have a sparkey wire up plugs into the humidifier, light, fan and fridge.. they all plug into my super sexy grey box that has 4 plug holes on it ( ill send you pictures)..The inside of the box - a 4 switch relay... to power the toys a connection and lead in that gives power…. And I have access to the liitle LCD screen to adjust the parameters when needed.I assume I need to get more electrical/computer parts for this.. and the program written that controls all this info.any info will be rewarded with salami.!!!!!!!
Question by BojanG4