Search for venturi nozzle in Topics


Coanda effect in conjuction with Venturi effect !?

I am still working on my project to create relatively accurate model of a Repulsine. No, I am not one of those free energy nut balls, just curious in old tech ;) As part of my research I came across some statements in regards to lost pieces of the Repulsine. The last remaining model still exists in Austria but noone seems to have to clue what the missing parts looked like. I think the missing parts are a system of nozzles, diverters and a secondary hull - forming a similar system like the Coanda plane engine. There are lots of people still out there tinkering with Coanda lifting devices and trying to get them working. Is there anyone here doing it ??? Would like to exchange some knowledge, tipps, designs and so on. Short term goal is to make working Coand engine with enough thrust / lift to be used at a later stage for a working Coanda plane model. Long term goal to modify it all to incorporate into the Repulsine.

Topic by Downunder35m    |  last reply


Building a Foundry?

So I've been experimenting with building a mini foundry made out of steel cans. I've experimented with several different fuels, fuel injection systems, oxygen injection systems, crucibles, and different metals. However, the only metal I've ever been able to melt with it is zinc. (if you don't know, zinc doesn't take alot to melt; only about 700F) My target metals are aluminum and copper, but despite over a year of experimenting, I've never been able to melt either. I would like to know what I'm doing wrong, or what I could do better. Here's the rundown of the furnace's construction: The fuel I'm currently using is propane. The foundry isn't big, (you could fit it in a backpack) so I just use propane canisters for torches with a normal output line on the end. The line runs to a small piece of glass laboratory tubing with a tiny nozzle on the end which is about 1 mm in diameter. The propane shoots out as a stream and mixes with air utilizing the venturi effect. The propane mix then shoots into a large metal pipe about 2 cm in diameter. It then bends up at a 90 degree angle and enters the furnace, which is in essence, a steel can with a hole in the bottom. inside this is a steel can cut in half with a thick wire through it to suspend it above the burner.  So what could be improved? When I run it at full blast, the whole furnace glows orange, but no metal melting happens...

Question by tylervitale    |  last reply