Author Options:

Arduino bootloading circuit Answered

Hi everyone, I have a short question. I am making a project that uses a ATmega328P and I'd like it to be stand alone, so I have been burning bootloders on this chip but only on the DIP socket and with a shield I made after a tutorial. I know that when burning the ISP you can't have anything connected to the board, and I was wondering if you must have the same conditions for the bootloading procedure since I am going to use the TQFP32 package and it is going to be a little bit difficult to make a shield for it. So if I solder everything to the board and put a connector for the ISP do you think it will burn the bootloader?


The forums are retiring in 2021 and are now closed for new topics and comments.