5Views0Replies

Author Options:

Combining a split face? Answered

Somehow I ended up with a split face where the lock hasp goes through. I have looked around and I cannot figure out how to combine this or go back into the timeline and remove whatever has caused this.

The only problem that I am having because of it is that I cannot put a fillet across it. I have uploaded a picture to illustrate what I am talking about, but it is an issue on both lock halves. I think there is a line on the hinge side too, but it coincides with the hinge pin and is not an issue there.

Any suggestions on fixing or repairing this?

Discussions