2Views0Replies

Author Options:

Error TSS01: Groove tool not found for following specs:? Answered

I'm getting an error in Featurecam when I try to run the 3d simulation in the Instructables lesson 1 : Intro to turning. Everything has been fine up until Video 4 at about 6:00 mins in, I modified the boring bar and added a cutoff like the video shows, but something's not right when I try to run the 3d simulation.
Error TSS01: Groove tool not found for following specs:
Width = .250
Angle = 0.0
Depth = .030

Error: FST01
What can I do to fix this error?

Discussions