61Views6Replies

Author Options:

Help With Digital Clock ! Answered

It has been very long I am trying to make a layout for Digital clock, but I FAIL.

I made the schematic but For Layout I Fail ! !

I fail in [b]Component Placing[/b] ! ! ! !

Please Can anybody make a layout for me


software used : Eagle v5.3.0

Comments

The forums are retiring in 2021 and are now closed for new topics and comments.
0
steveastrouk
steveastrouk

9 years ago

No load caps on the crystal.
NEVER use an RC reset on a Flash processor - find a reset generator chip.

Layout ? Do it by hand. This is so simple I can do it in a few minutes.
Hint: where you have a free choice of what your address lines to the display actually represent, wire the parts as simply as you can

0
ashirwad
ashirwad

Reply 9 years ago

tried a lot
but still some wires are left as Air wires ! :(

Please can you do it for me \
(If dat sounds as spoon feeding for me then at least you show me component placement ! )

0
steveastrouk
steveastrouk

Reply 9 years ago

Don't autoroute it, its very very easy to do by hand !

I hate autorouters.

Steve

0
ashirwad
ashirwad

Reply 9 years ago

Please can you show me Component placement !

See I don't mind it doing by me , but the thing is I can't place them and connect them.
just show me the design I will draw it on my on , Please .

0
steveastrouk
steveastrouk

Reply 9 years ago

Can you not drag them onto the board ? I just did.

Steve

0
steveastrouk
steveastrouk

Reply 9 years ago

I don't use Eagle ! I use a different professional system.

Steve