216Views3Replies
How to make a laser out of these components?
So, up to now i have gathered a Phr-803t sled, which most of the laser enthusiasts are familiar with, a laser housing for 405nm laser diodes( http://www.o-like.com/index.php?main_page=product_info&cPath=4&products_id=23 ), and a laser diode driver again from o-like ( http://www.o-like.com/index.php?main_page=product_info&products_id=93 ).
Can i make a laser using these components and if so, how can this be done?
Thanks in advance.
Comments
10 years ago
Well, the diode drives the design, not the driver. If you HAVE a diode that runs on 4.8V at 1.1 Amps, this setup is for you
Steve
10 years ago
Well, now you need a laser diode !
Answer 10 years ago
Well, i have the laser diode(it's inside the sled) but i don't know how to put this all together, and since most of the laser builds use the aixiz module i have no idea how to all these things together( i have an o-like module).