11Views1Replies

Author Options:

No code to upload to Arduino board? Answered

Good morning, I am very worried now. I have been trying to learn and make these circuits but the task is becoming very sad because all my circuits are not working on tinkercad. The problem is that when I connect all these components no code is written and therefore I have no code to send to my arduino to run. This happens over and over again. I was only able to simulate circuits from lesson 1.

Discussions

None
bekathwia

4 weeks ago

Hi Tseke, you must add the code for each component as directed in these lessons (copy/paste or type it). Tinkercad Circuits does not add code when a component is added to your design.