18Views0Replies

Author Options:

RC aircraft set up problems Answered

Hi all,

I am new to the world of RC aicraft, I have purchased 4 complete used (probably the wrong move) scratch built RC aircraft which have a variety of RXs and servos.

The planes came with no TX, so I purchased a used but good (so I'm told) Sanwa RD8000 35Mhz TX (all of the RXs are 35mhz), I purchased a no.64 crystal (I could only get a Futaba one which I hope is the same) for the TX to match the RX crystals.

I have programmed the TX the best I can keeping it simple, the problem is that when I switch on the TX the servos in the planes just either chatter or drive erraticly from end to end and seem to have a mind of their own.

Any ideas ??

Please note! I'm an old guy soplease be gentle with the terminology and technology.

Comments

The forums are retiring in 2021 and are now closed for new topics and comments.