Introduction: Ear-bud Converter

About: I am a part time college student and full time geek.

I was looking for some new ear-buds the other day I wanted ones i could exer-size in and where around town and not be annoyed by the over the ear holders so i decided to make me some. I am 16 and listen to a lot of media and I go through a lot of head phones.

The first thing that you have to do is go to this web site and download 123D design.

its that easy so far so good.

Step 1: Step One

The next thing that you have to do is start by drawing a path  with the contour of your ear i found a picture of a ear and designed it from that.

Step 2: Step Two

the next thing is to set up a cylinder parallel to the path.

Step 3: Step Three

The next thing that you have to do is use the sweep tool to go along the path so you can have something to hang over your ear.

Step 4: Last Step

The last thing that you have to do is to add a a cylinder that i holed out using the shell tool and then cut it in half and added it to the ear but holder. and that it vote for me in the design contest.

Autodesk 123D Design Challenge

Participated in the
Autodesk 123D Design Challenge