Introduction: Env2 Phone Stand
i wanted a stand to put my phone in but i could not find one on the instructables site so i made one out of knex
Step 1: Parts List
parts:
7 blue rods
4 granite rods
2 gray rods
10 black rods
4 blue connectors
5 half moons
3 brown/orange connectors
4 white connectors
4 granite connectors
2 black connectors
1 black rod/connector*
total parts: 46
*not shown
Step 2: The Back
build
Step 3: The Support
build
Step 4: Assemble the Holder
no comment
Step 5: The Base
build
Step 6: Assemble Stand
no comment
Step 7: You're Done!
If you've done this right it should look like this:
fold your phone open to set it in the stand
don't forget to comment and rate!
5 Comments
11 years ago on Step 7
where i put my phone??
:P
11 years ago on Step 7
where i put my phone???
:P
14 years ago on Introduction
Cool and clever! Works with any ipod, except the mini and the nano and all the little ones , andhas room for a charging cable! 4.5 *!
Reply 14 years ago on Introduction
thx i made it so that i could charge my phone while it was on the base
Reply 14 years ago on Introduction
Ya i hate my nano, its to small to work with and i feel like if i drop it, it would break...