Cargobike in Progress

By in OutsideBikes

1,534

2

1

Introduction: Cargobike in Progress

Hey, this is the bender that I use, as you can see it is a very simple one. but it do the trick. I am a beat "stuck" with the rear end, how to do the cable to the gear and brakes? if anyone have a good idea ?it will be very helpful.  hope you like the progress.  dotan

Bike Contest

Participated in the
Bike Contest

Be the First to Share

    Recommendations

    Strap-On Cleats for Ice and Snow Traction
    Strap-On Cleats for Ice and Snow Traction by Zero To Infinity in Snow
    50 5.4K
    DIY Wheels for Bike or Trike or Trailer
    DIY Wheels for Bike or Trike or Trailer by Liebregts in Metalworking
    104 22K
    Be Seen! 3D Printed Bike Lights With Fusion 360
    Be Seen! 3D Printed Bike Lights With Fusion 360 by Kevr102 in Bikes
    57 10K
    Hollow Wood Surfboard - Plywood and Cedar
    Hollow Wood Surfboard - Plywood and Cedar by memestra in Beach
    167 17K

    • Big and Small Contest

      Big and Small Contest

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    • Make It Bridge

      Make It Bridge

    Comments

    0
    neil1701
    neil1701

    9 years ago on Introduction

    Not sure about how you are going to attach the rear derailleur to the bike but from what i see in the pictures,perhaps cables in full outers attached with tie wraps or strong tape like duct tape might help.Dont know if this will help you any but just offering my advice.