Home Made Pinball Machine
Intro: Home Made Pinball Machine
To make a pinball machine you will need a thick peice of rectangular�ply wood , a small 2x4,�lots of rubber bands,lots of nails,duct tape,2 bolts,a marble,and a pipe not much bigger than your marble.
STEP 1: Making the Walls
For the walls you will need to place the nails in the wood to streach the rubber bands between.
STEP 2: Making the Hitters
For the hitters you will need to take your bolt and cover it in duct tape,them put a nail between the boalt and the other nail so that it can move freeley.
STEP 3: Puting the Rubber Bands on the Hitters
next you will need to wrap a rubber band around the rear or the hitter,then run it to the bottam of the board and wrap it around a nail.
STEP 4:
next take your pipe and a pice of 2x4 and tape it down to make the starter.
STEP 5:
last take your 2x4 and nail it to the boatom of the board to make a slant [you can add more wood to the bottom to make the game harder]
4 Comments
The nerdling 12 years ago
justindouthat 12 years ago
The nerdling 12 years ago
rimar2000 13 years ago