Introduction: How to Make a THROWING KNIFE
After finding an old line pin I could see it as a throwing knife so in a few steps I transformed it into a ..... well a throwing knife.
Step 1: Mark Your Path
Start by marking your bevel ,where you going to grind to.
Step 2: Grinding !
Then take the line pin to the grinder grinding to the line as shown , make sure the tip is sharp but not to thin then clean it up on the belt sander/grinder.
Step 3: Throw
It may take a bit of practice to get hit your target , I have now mastered it after watching few YouTube videos on on how to throw one and what seems to work best is to hold the blade part between you thumb,index and middle finger and throwing it like a javelin but with a spin.
If you made one you can comment down below and leave a picture or email me at email@example.com