Introduction: How to Make a K'nex Knife Holder
final product
Step 1: Collect These Bits
8×blue washers
4×grey washers
4×blue clips
4×grey connecters
4×grey rods
2×yellow rods
10×red connecters
4×brown clips
2×white rods
8×blue rods
Step 2: Sides
make these and slide grey bits on
Step 3: Pocket Clips
make these
Step 4: Choose
choose where to clip the bits in place
Step 5: Clip
clip in these bits and add grey and blue spacers
Step 6: Bottom
clip in the white bits and add spacers
Step 7: Front
clip the other side side in
Step 8: Attach
attach pocket clips and washers
Step 9: Slide
slide the left over washers onto the supports