How to Make a Duct Tape Wallet

5,835

12

6

Introduction: How to Make a Duct Tape Wallet

This Instructable is how to make a duct tape wallet.

Step 1: Materials

Duct tape ( One roll )
Scissors
and one piece of 8.5 in. x 11 in.

Step 2:

Duct tape ( One roll )

Step 3:

one piece of 8.5 in. x 11 in.

Step 4:

First, cover the paper in the tape.


Now the other side.

Step 5:

Now the other side.

Step 6:

Now fold in half, hot dog way if you know what that means.

Step 7:

now cut it about 7 or 8 inches.

Step 8:

Cut the top however high you want, and cut.
I chose 3 inches.

Step 9:

Next tape up the sides.

Step 10:

If you want to make some card holders you can use the pieces you cut off.

Step 11:

This is what it looks like with the pockets in it.

Step 12: Done

now your done, now you can buy different colored tape and make different designs.

Epilog Challenge

Participated in the
Epilog Challenge

Be the First to Share

    Recommendations

    • Sew Warm Speed Challenge

      Sew Warm Speed Challenge
    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest

    6 Discussions

    0
    kadaj16
    kadaj16

    10 years ago on Introduction

    Question what would happen if u put 1 color of tape like the strip of it on the paper the did the same thing only with a different color?

    0
    playahboy
    playahboy

    Reply 11 years ago on Introduction

    No you dont, but i did in that for beginners that dont know the lay out

    0
    lemonie
    lemonie

    Reply 11 years ago on Introduction

    You should point out how this is different from / an improvement on those. L