Сandle Holder

22

1

1

Introduction: Сandle Holder

Сandle Holder creation:

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Сreation of a New Project

Сreate a new project in the Selfcad program as shown in the picture

Step 2: 1st Part

Use the Image to 3D to create a first part.

Step 3: Base and Holder

Create few more cubes to make a base for the angel

Step 4: Snowflakes

Create a few snowflakes using a tool Image to 3d

Step 5: Filal

Move the snowflakes to the places as shown in the pictures

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Warm and Fuzzy Challenge

      Warm and Fuzzy Challenge
    • Wearables Contest

      Wearables Contest

    Discussions

    1
    seamster
    seamster

    5 weeks ago

    Nice design! Is this something you've actually printed? If so, you should share a photo of the printed version too : )