3-D Snowflake

1,557

24

2

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Supplies

A stapler
A pair of scissors
6 pieces of paper

Step 2:

First you have to fold down the top corner, then cut off the bottom to make a square. Do this to all 6 pieces of paper.

Step 3:

Then make 3 diagonal cuts on each side of the triangle about and inch apart. And do this to all 6.

Step 4:

Unfold the triangle and flip to over. Then roll the up the middle section and put a piece of tape on it.

Step 5:

Flip over and put the 2 ends together, then tape. After that, flip over and put those 2 ends together and tape. Repeat this step and the last step and do that to all 6 pieces of paper.

Step 6:

Step 7:

Next put 2 of the pieces together, pinch the bottom and staple it together. Also put a staple in the middle as shown in the picture.

Step 8:

Add the third piece on and staple. Then put the other 3 pieces together.

Step 9:

Next put the 2 pieces together and tape the middle. After that staple the 2 loops together where there not connected and the same to the other side. And done!!!
(Also there is no step 6 I accidentally added it, in case you were wondering)

Crafting 101

Participated in the
Crafting 101

Share

    Recommendations

    • Make It Fly Challenge

      Make It Fly Challenge
    • Stone Concrete and Cement Contest

      Stone Concrete and Cement Contest
    • DIY Summer Camp Contest

      DIY Summer Camp Contest

    2 Discussions

    0
    None
    ndouglas303

    4 years ago

    We do this at our school for an art project. Cool.