3D Printed Straw Connectors V6

Published

Introduction: 3D Printed Straw Connectors V6

About: I'm a Research Engineer at Adobe. Previously, I was a grad student at the Center for Bits and Atoms at MIT Media Lab. Before that, I worked at Instructables, writing code for the website and iOS apps and m...

As a follow up to my original post about a 3D printed straw construction set, I've made a new shape of connector.  This new connector  joins four straws in a vertex.  I printed this connector with an epilog printer (the grand prize in the Make it Real Challenge!)
I've attached the AutoCAD and stl files below.

Share

    Recommendations

    • Water Contest

      Water Contest
    • Clocks Contest

      Clocks Contest
    • Creative Misuse Contest

      Creative Misuse Contest

    Discussions