3d Printed Monkey Fist Jig

About: I am a teenager who is studying Principles of Engineering at DTSMA high school and a future engineer.

This is for those Boy Scouts, the military men, or the average knot fanatic who no matter how hard they try, they just can't get a good monkey fist without a jig. Well, worry no more, folks, for the solution is here!
Please note that this is a design only due to the fact that I don't have a 3d printer, but I am saving and entering this in the 123d contest.
Please note also I am not responsible for anything that may happen with this or anything that might come from this

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.



    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Metal Contest

      Metal Contest
    • Make It Fly Challenge

      Make It Fly Challenge

    3 Discussions


    Reply 5 years ago on Introduction

    sorry about that; this is my first 123d design instructable and I will get the measurements as soon as possible


    Reply 5 years ago on Introduction

    I look forward to it. I hope to build one someday and finding the measurements is as hard as finding a good instructable (which yours seemed very good).