3d Printed Cookies

5,400

41

5

3D PRINTED CHRISTMAS COOKIES

Printer is a modyfied BFB Rapman

extruder: UNFOLD Claystruder 1.1 thingiverse.com/thing:3604

software: Rhino , Skeinforge

I expordet the file as a single surface to make suhre to have a single extrution  line

Spritz Cookies:

1 cup (227 grams) unsalted butter, room temperature

1/2 cup (100 grams) granulated white sugar

1 large egg

1 1/2 teaspoons pure vanilla extract

2 1/4 cups (295 grams) all purpose flour

1/4 teaspoon salt

Spritz Cookies:  Preheat oven to 350 degrees F (177 degrees C) and place rack in center of oven. You will need two ungreased baking sheets.

In the bowl of your electric mixer, or with a hand mixer, beat the butter and sugar until fluffy (2-3 minutes). Add the egg and vanilla extract and beat until incorporated. On low speed, gradually add the flour and salt and mix until incorporated.


Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Cookie Contest

Participated in the
Cookie Contest

UP! Contest

Participated in the
UP! Contest

Share

    Recommendations

    • Spicy Challenge

      Spicy Challenge
    • DIY Summer Camp Contest

      DIY Summer Camp Contest
    • Games Contest

      Games Contest

    5 Discussions

    0
    None
    dan3008

    1 year ago

    mmm, cookiestruder

    0
    None
    lopar666

    5 years ago on Introduction

    Yum, print your name or party guests names, personalized cookies FTW.

    0
    None
    vorwaertz

    6 years ago on Introduction

    thank you ! about 2cm hight because in the oven it flows a bit and makes the structure smoother! if you´ll print to hight you end up with no more structure! And the wall thickness depends on the air pressure. you can print thiknesses from 1mm up to 7mm.