Introduction: 4 LED FLASHLIGHT

About: I love to learn,build and design.....

AIM:To construct LED torch (4 led's in parallel)

APPARATUS REQUIRED: Soldering iron,multimeter , gum tapes.

COMPONENTS REQUIRED: Led's(4),battery container(6V),Wires,pressing switch,batteries(rechargeable recommended),resistors(if required),reflector.

First connect leds in parallel then connect it to switch then to battery if led are connected in series voltage at each led will be different
so to cope up with this leds are connected in parallel. As we have connected leds to rechargeable batteries each battery is of 1.2V so 4 batteries in series make 4.8V which is enough to light the led.  

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

Step 2:

Connect leds in parallel

Step 3:

Circuit diagram

Step 4:

Step 5:

If the leds are becoming  very hot you can use a resistor to resist some amount of current and intensity of the light is also lost but battery may come for longer life...

Be the First to Share


    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge



    6 years ago on Introduction

    i will try because i got an idea to publish after i finished the project,or i will do better in my next instructable

    Thanks for advice....