4in1 Multi-module Protocol for FrSky Taranis


13,307

19

1

The ultimate universal transmitter radio for RC models.

Tutorial on how to install the 4 in 1 module for the FrSky Taranis X9D Plus from BangGood.com. When this module with updated firmware is installed, it can almost replace every transmitter for your RTF micro multi-rotors/quadcopters/helicopters and planes.

This module makes the Taranis X9D compatible with many protocols including:

Spektrum DSM2/DSMX (Blade/E-Flite) FlySky Hubsan Syma WLToys HiSky KN YD ... more

4in1 Multi Protocol Module for FrSKY Taranis / JR / FlySky 2.4G CC2500 A7105 Flysky Frsky Devo DSM2 Multiprotocol TX Module With Antenna http://bit.ly/bg4in1module

Multi Protocol TX Transmitter Module Case for FrSky FlySky http://bit.ly/bg4in1case

4in1 Multi Protocol Module for other DIY transmitters http://bit.ly/bg4in1diy

3in1 Multi Protocol Module for Devo Transmitters http://bit.ly/bg3in1devo

FrSky 2.4G ACCST Taranis X9D Plus Transmitter With X8R Receiver http://bit.ly/bgtranisx9dplus

Eachine Backpack Bag Case for Frsky X9D Plus http://bit.ly/bgx9dcasebag

Misc Taranis Related parts http://bit.ly/bgtaranismisc

RCGroups thread http://www.rcgroups.com/forums/showth...

MultiModule Taranis Firmware http://plaisthos.de/opentx/

Protocol mapping https://github.com/pascallanger/DIY-M...

Multi Protocol Tx module case for Taranis http://www.thingiverse.com/thing:1691786

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

FrSky Taranis OpenTX model setup files (4in1-taranis-MODELS.zip)

Be the First to Share

    Recommendations

    • Assistive Tech Contest

      Assistive Tech Contest
    • Reuse Contest

      Reuse Contest
    • Made with Math Contest

      Made with Math Contest

    Discussions

    0
    None
    suzygs1000

    Question 8 months ago

    Hi, I have recently switched from a Devo 10 to Jumper T12, to try and avoid the dozens of transmitters I have amassed from purchasing RTF Quads and Helis. My decision was also influenced by the number of BNF models becoming available. I am slowly coming to grips with the OpenTx on the T12, but one area is perplexing me greatly. With quads, the channels in use can be set in OpenTx and then on the FC. With flybarless helis, however, how can you work out which channels are used for arming, and flight modes. I at first thought that these would be set in the TX, which would seem to be ok for rates, and collective pitch, but with the flight modes, where you have angle mode, rate mode, etc, this info is contained in the FC, so how can I tell which channel to use, or is it just trial and error? Hope you can help me

    regards Dave.