5 to 1 Gear

Intro: 5 to 1 Gear

3D printed gears

Bevel gear design to create a 5:1 ration allowing a 200 rpm motor to drive the robot at 1 ft/sec

size restrictions dictated that drive fear must fin inside a .75" radius tube

Each gear was designed using solidworks and printed using a 3D printer at VCU


Share

    Recommendations

    • Audio Contest 2018

      Audio Contest 2018
    • Optics Contest

      Optics Contest
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge

    Discussions