7 SEGMENT DIGITAL CLOCK AND THERMOMETER

About: I am a high school teacher of electronics

It is operated by 12v 500mA adapter.The character height is 57 mm and it shows the hourly information over 24 hours.Time and temperature information are displayed alternately on the same screen.It does not forget the clock information via the memory chip installed on the circuit.There are 3 buttons for mounting on the box.One of these is the MOD button, which is used to change the minutes and hours.The other 2 buttons function to increase and decrease

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: How to Make This Project ?

Step 2: Equipment List

16F628A

74HC595 X 4

ULN2003 X 4

DS1302

DS18B20

57MM COMMON ANODE DISPLAY

32,768 KHZ OSC

CR2032 CLOCK BATTERY

7805

7809

10K RES X 5

4K7 RES X 5

220 OHM RES X 30

5 MM RED LED X 2

Step 3: START TO PROJECT

First of all, as you can see in pics, you have to put in all jumpers. And next step...

Step 4: Resistors and IC Sockets

You can see details on pics and PCB layouts and material lay outs. This schematics will help you. Firstly, you use resistors. and than ıc sockets.

Step 5: Displays

And the last step, put Displays. And go...

Step 6: Hex Code

You can find Hex code for clock. Send to your PIC.

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Make it Move

      Make it Move
    • Teacher Contest

      Teacher Contest

    Discussions