A Pen With No Lathe

A challenge presented by Bill Livolsi of One Car Workshop, and accepted by me. I used primarily hand tools to create a "dip pen".

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

Design & Build a Truncated Icosidodecahedron! by MichaelMikkelson in 3D Printing

86 8.7K

Miter Saw Dust Collection by diymontreal in Woodworking

8 1.4K

Make a Six Board Chest With Home Center Lumber by dave.vaness.79 in Woodworking

65 3.8K

3D Printing With Circuits C...

7,234 Enrolled