Ok, time to make a fan, you may do it for whatever you desier. the parts you may need are
The most powerful motor you can get....Well...Within fan limits of course....(and fan limits arnt car motors, those big giant blow-you-away fan motors eather....You get what i'm saying.)
A switch. three termanals for soldoring
A small box, i used one of them raideo shack boxes
A battery holder.
A fan blade, or supplies to make a fan blade.
The end result is the picture :D
Not bad for a 13 year old Nerd with a mohawk, eh?
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Drill Holes.
One hole in the front, for the motor fan blade to stick out
one for the on/off switch
Wereever you want for the on/of switch
Step 2: Place Everything.
NO pictures for this one, because i dont want to ruin my fan
But you place the switch the way its suppose to go, and you put the motor bit through the hole oh, and glue the motor to the hole (Not the place were the blade goes, but around the bit, so the bit can stick through the hole
Step 3: Put the Blade On
The reason i put this step this far in, is because....
You gotta put the blade on with the motor in XD And no pixx for this eather. sorry, just add the blade with glue or wedge, witchever the blade can do
Step 4: Wire!
Wireing is simple. heres the diagram (I'm so nice that i dont make you look it up, rigght? :D)
And put the posative wire from the switch and the negative wire in the right place, you'll know where the right places is from the way the blade spins, if it blows air its right, if it blows air back, its wrong