This is a simple project for beginners who have just started using Arduino.
This project uses a PIR Motion Sensor and a 16X2 LCD Module to display when the motion was detected and when the motion stopped.
So,just follow the steps to make this project.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: PARTS Required
The parts required are:-
1. 1 X Arduino board(UNO,MEGA,Pro Mini,NANO etc)
2. 1 X PIR Motion Sensor
3. 1 X 10k Trim Pot
4. 1 X LCD 16X2 Display Module
5. 10-20 X Jumper Wires
Step 2: Circuit Diagram
Wire up the circuit using the circuit diagram
Step 3: Code
Download the code.
Upload to your Arduino board and it will start working.
Thanks for viewing my instructable.