AirFlo Bed Frame

I really like having my mattress on the floor, but because of the possibility of mildew it's not really the smartest idea to just let it lay on the ground. Here is a simple idea that will raise the bed just high enough to allow air to flow beneath the bed. Hope you enjoy! 

Share

    Recommendations

    • DIY Summer Camp Contest

      DIY Summer Camp Contest
    • Planter Challenge

      Planter Challenge
    • Sew Tough Challenge

      Sew Tough Challenge

    4 Discussions

    0
    None
    ewfw

    5 years ago on Introduction

    Smart move, did you have to put spacers to keep the boards from sagging in the middle?

    0
    None
    Odditiesyurika975

    Reply 6 years ago on Introduction

    A simple 1X6 in the two middle and 1X4 for the rest, but I'm pretty sure you could use either for all.

    0
    None
    yurika975

    6 years ago on Introduction

    Good idea. Wonder if you could just add a few legs for additional height?