Alarm on Leak

8,235

160

7

Introduction: Alarm on Leak

Today we are going to do about the leak alarm, which can be placed in hard to reach places.

The creation of such a signal was the incident happened at my house. Synulya unnoticed by us pulled the drain hose washing machine. The machine washed. And we were at home and did not know that we had was the bathroom and the water flowed out into the corridor.


Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: ​We Will Need.

We will need.

  • Battery 3 volt CR1632
  • One transistor BC517, BC816 or any other NPN Darlington.
  • Resistor 1-2 megohms.
  • Piezo electric buzzer

Step 2: The Scheme Is Very Simple

Step 3:

connect a transistor and a resistor

Step 4:

connect buzzer

Step 5:

connect the battery

Step 6:

We put into the body

Step 7:

placed in hard to reach places

The more detail you can see in the video.

1 Person Made This Project!

Recommendations

  • Magnets Challenge

    Magnets Challenge
  • Raspberry Pi Contest 2020

    Raspberry Pi Contest 2020
  • Wearables Contest

    Wearables Contest

7 Discussions

0
hmv4u
hmv4u

3 years ago

I like it,any idea how long the battery would last ?

0
gulliverrr
gulliverrr

Reply 3 years ago

Indeed.... for how long do they run if they are never triggered?

0
DIY Hacks and How Tos

These are great simple alarms. I have a few in my crawlspace to look out for leaks.

0
ILYANOV
ILYANOV

Reply 3 years ago

Hey. I will see everything.

Thank you very much for your letter.