An Electrical Mosquito Repelent

Introduction: An Electrical Mosquito Repelent

This is a simple plug and play mosquito repellent. It comes in very handy.

Step 1: What All You Will Need.

You will need the following:

A piezoelectric transducer

A 1000 ohms rectifier diode

An electric socket

An led

Acrylic

A transient voltage diode 1500W

Two Capacitors

Step 2: Soldering Together

Solder all the components together on a perfboard and add the plug socket

Step 3: Adding the Cover

Find a suitable cover for the circuit board to be kept in. I got mine from one of those plug and play electric speakers.

Share

    Recommendations

    • Water Contest

      Water Contest
    • Tiny Home Contest

      Tiny Home Contest
    • Metalworking Contest

      Metalworking Contest

    8 Discussions

    It doesn't look like you soldered the components in place... You would have to make your own PCB for that. It's obvious that you didn't solder at all

    It looks to me like the answer to shivamgautam's question would be "Yes"

    I think I've read online that these are fake, They don't repel mosquitoes at all

    Sorry, But this is FAKE (Tell me why this isn't fake...)

    "A 1000 ohms rectifier diode" ? ? ?

    (Title) "Repelent" should be Repellent.

    :)

    2 replies

    Yup a 1000 ohms rectifier diode

    and i shall correct that spelling it usually does not happen. Thank you and please vote. :]

    1K ohms, Isn't it a resistor?

    You didn't correct the title...

    Didn't you just disassembled a commercial mosquito repeller and assembled it back again? :D

    2 replies

    nope i actually opened a lot of them and learned about them. After that i made one exept it turned out to look like on of the commercial repeller

    hi,

    is there a circuit diagram? what is the frequency of the oscillator? how did yhou pront the silk screen on the board?

    Cool!