Arduino Color Mixer Controlled by IPhone

4,531

18

5

Robot contest 18+

This is the video demonstration of what the final product will look like.  This could also easily be used to control an arduino robot or anything at all that the arduino is running!

if the video won't play here is the link http://www.youtube.com/watch?v=hqgcAuNUyR0



www.doityourselfharry.com

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: How to Tutorial

Here is the how to!

if the vid doesn't open here is the url http://www.youtube.com/watch?v=s9etKD2y-Zk

Step 2:

Wires coming from ground, 11 pin, 10 pin, and 9 pin

Step 3: Wiring for LEDs

This should be pretty simple.
You have the wiring from the arduino for each color connected to the positive side of the led and the grounding wire from the arduino is grounding all of them.  They are running in parallel to each other and in series with a resistor.

Step 4:

This is what the final setup will look like.

National Robotics Week Robot Contest

Finalist in the
National Robotics Week Robot Contest

3rd Epilog Challenge

Participated in the
3rd Epilog Challenge

Be the First to Share

    Recommendations

    • Assistive Tech Contest

      Assistive Tech Contest
    • Reuse Contest

      Reuse Contest
    • Made with Math Contest

      Made with Math Contest

    5 Discussions

    0
    None
    KevinAlien26

    7 years ago on Introduction

    Are you planning on releasing the codes because I unfortunately haven't begun my processing classes so I am pretty clueless as to what is going on. This is a great instruct able by the way!

    0
    None
    jebro391

    8 years ago on Introduction

    Hey buddy, great project! really love it!! I've got the TouchOSC working on my IPOD and the processing sketch up and running, but when I run it, the processing sketch doesn't do anything; it's just 3 empty rectangles. Any thoughts? i've checked and re-checked the code and can't find any errors, and it runs so there's not syntax errors. It's got me stumped. I'm pretty sure I have the oscP5 library added properly or else it wouldn't run. I have the IP address from the console loaded onto the IPOD (the TouchOSC still imports, so I'll assume that's not the issue). So if you have any ideas or thoughts, i'd appreciate the help. I'm gonna hold of on the Arduino-portion of this until I can get the processing sketch figured out. Thanks for the great build! -Joe

    0
    None
    zazenergy

    8 years ago on Introduction

    Wow, this is pretty awesome! I just took a class in Processing a while back, it's great to see applications of it.

    1 reply
    0
    None
    hbjacksonzazenergy

    Reply 8 years ago on Introduction

    thanks! This was my first tutorial so if you have any questions or comments on how I could make it better or more clear that'd be great.