Arduino - PIR MOTION ALARM & Keypad DSN FIR800 RCW 0506

Introduction: Arduino - PIR MOTION ALARM & Keypad DSN FIR800 RCW 0506

About: Hello world! I make simple & Advanced projects for people who want to learn programming and electronics. Most of my Instructables are about arduino and the wide range of sensors you can use with it. I ma...

Hello world! Today i made a simple and very cheap to build alarm System with a keypad, pir sensor, relay and a very loud alarm strobe. You have 30 seconds time to leave the room after activating the alarm system, of course this can be changed in the code to less or more seconds. Now it has been set to 30000 milliseconds.

You can change it at this line in the code:

  • const int timeDelay = 30000; //give yourself time to leave the room

Follow the next step for the Schematic, Code & Parts list.

Step 1: Schematic, Code & Parts List.

Simply wire it up like the schematic, Upload the code and it should work.

Make sure you have these libraries installed, download them below.

Parts list:

  • Arduino uno, I used the RobotDyn uno. Which has 2 extra analog pins
  • Potentiometer
  • LCD 1602
  • Pir motion sensor DSN FIR800
  • Ky-019 Relay module
  • 1 x Blue Led
  • 1 x Red led
  • 2 x 1 k Resistor.
  • 4x4 Keypad
  • 12v Alarm Strobe

Good luck!

Be the First to Share

    Recommendations

    • Puzzles Speed Challenge

      Puzzles Speed Challenge
    • "Can't Touch This" Family Contest

      "Can't Touch This" Family Contest
    • CNC Contest 2020

      CNC Contest 2020

    2 Discussions

    0
    RayyanN
    RayyanN

    Question 1 year ago on Step 1

    i think some think is wrong with code