Arduino Servo Control

Servo motors have three wires: power, ground, and signal. The power wire
is typically red, and should be connected to the 5V pin on the Arduino board. The ground wire is typically black or brown and should be connected to a ground pin on the Arduino board.

Step 1: Parts ....

* ARDUINO UNO

* SG 90 SERVO

* MALE - MALE JUMPERS

Step 2: Wiring .......

Connect The Servo [BLACK] Wire To Arduino GND ...

Step 3:

Connect Servo [RED] Wire To Arduino 5v .......

Step 4:

Connect Servo [ORANGE] Wire To Arduino Pin 9

Step 5: SCHEMATICS ......

Step 6: More Info .......

Arduino Software :-- https://www.arduino.cc/en/Main/Software

---------------------------------------------------------------------------------------------

Code :-- http://www.mediafire.com/file/hywbxkewcyx47vo/Ser...

-----------------------------------------------------------------------------------------------

Buy it from Utsource

---------------------

Arduino Uno :-- https://in.utsource.net/itm/p/8647184.html

Servo :-- https://in.utsource.net/itm/p/9221287.html

Male - Male Jumpers :-- https://in.utsource.net/itm/p/9221306.html