Arduino: Simple Sequential LED's

About: Moving fast and breaking things!

In this instructable, we are going to construct the circuit and write the code to control the state of three LED's sequentially using the Arduino Uno board.

Parts Needed:

Arduino Uno

Arduino Software (Can be downloaded for free from Arduino)

Breadboard

Three LED's (any color)

Three 330 ohm resistors

Wires as needed

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Schematics, Code, and Demonstration

Figure 1 shows the schematics for this project on a breadboard.

Figure 2 shows the code for this project.

Finally, the attached video is a demonstration of the complete project.

Full Spectrum Laser Contest 2016

Participated in the
Full Spectrum Laser Contest 2016

Hack Your Day Contest

Participated in the
Hack Your Day Contest

Raspberry Pi Contest 2016

Participated in the
Raspberry Pi Contest 2016

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest

    Discussions