Arduino - Touch Sensor Switch Using the KY-036

Introduction: Arduino - Touch Sensor Switch Using the KY-036

About: Hello world! I make simple & Advanced projects for people who want to learn programming and electronics. Most of my Instructables are about arduino and the wide range of sensors you can use with it. I ma...

Hello world! Here we go again!... I made another example on one of the sensors i got.

This time i made a example for the KY-036 Touch sensor.

Follow the next step for the schematic and code.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Schematic Code & Parts List.

Just wire it up like the schematic and it should work after uploading the code.

Parts List.

  1. Arduino Uno.
  2. 3 Color led Module KY-016 (other separate leds will do to)
  3. Touch sensor Module KY-036
  4. Buzzer.
  5. set of Jumper wires MM/FF/MF

Good luck!

Full Spectrum Laser Contest 2016

Participated in the
Full Spectrum Laser Contest 2016

1 Person Made This Project!

Recommendations

  • Trash to Treasure Contest

    Trash to Treasure Contest
  • Raspberry Pi Contest 2020

    Raspberry Pi Contest 2020
  • Wearables Contest

    Wearables Contest

Discussions