Arduino Tutorial - Stepper Motor With Bluetooth

Introduction: Arduino Tutorial - Stepper Motor With Bluetooth

About: For more project and tutorial visit my YouTube channel Mert Arduino and Raspberry Pi

This instructable is the written version of my "Arduino : How To Control Stepper Motor via Bluetooth (with Smartphone)"

In this project we will control a Stepper motor with a smartphone via bluetooth. My YouTube Channel First, you should see the following Instructable: How to Control a Stepper Motor With L293D Motor Driver

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Tutorial

The Stepper motor used here is a rusty old EPOCH (5 wires) stepper motor, which is a unipolar stepper.

Step 2: Hardware Required

Parts Required :

- Bluetooth Module ( for example : HC05 or HC06 ) - Jumper Cables

Step 3: Circuit & Connections

Bluetooth Modul VCC to Arduino 5V

(at the same time if you want, you can use 3V3)

Bluetooth Modul GND to Arduino GND

Bluetooth Modul RX to Arduino TX

Bluetooth Modul TX to Arduino RX

Step 4: Programming

Get the Code and Application

*** When uploading code remove the Bluetooth Rx and Tx Cabel

Step 5: Create Application

I use "App Inventor" for create application

MIT App Inventor

Step 6: If I Was Helpful

First of all, I would like to thank you for reading this guide ! I hope it helps you.

If you want to support me, you can subscribe my channel and watch my videos.

My YouTube Channel

My Blogger

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions