Arduino UNO+Nextion Display

Introduction: Arduino UNO+Nextion Display

Hello, today im going to tell about uploading the project into Nextion TFT Display via Arduino Uno.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Equipment

I have Nextion 4.3" display

Step 2: Connection

you need to connect pins on Nextion and Arduino:

TX -> TX

RX -> RX

5V -> 5V

GND -> GND

Also you need to connect RESET pin on arduino to GND.

It's important!

Step 3: Nextion Editor

Create Nextion project and push UPLOAD

Step 4: Result

You can see something like this on your Nextion display

Thanks!

Be the First to Share

    Recommendations

    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020
    • First Time Author Contest

      First Time Author Contest

    Discussions