Arduino Powered Traffic Light

1,994

14

7

Introduction: Arduino Powered Traffic Light

READY

STEADY

GO GO GO

Step 1: TRAFFIC LIGHTS

Traffic lights are very important for roads as they control the flow of traffic.Making one of these is very easy and we r going to do it!!

Step 2: COLLECTING MATERIAL

Materials needed --:

a) Arduino Uno

b) Bredboard

c) 3 Red Led's

d) 3 Yellow Led's

e) 3 Green Led's

f) 7 Jumper wires

g) a 9 volt battery

h) Arduino programming software

Step 3: LED'S

First connect the red led's with the bredboard in a series.

Then connect the yellow led's in a series.

After that the greens.

Step 4: ARDUINO PORTS

The red led's are to be connected to port no.3,the yellows to be connected to port no.4 and the greens to be connected to port no. 5. the negative leads of all led's to be taken common and connected to the nearest ground or Gnd ports.

Step 5: Programing

The program fr the following is uploaded and you can download it from clicking the link given below.

Step 6: Photos and Videos

Automation Contest

Participated in the
Automation Contest

Explore Science Contest

Participated in the
Explore Science Contest

Be the First to Share

    Recommendations

    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Audio Challenge 2020

      Audio Challenge 2020
    • Maps Challenge

      Maps Challenge

    7 Discussions

    0
    skepticaljay
    skepticaljay

    5 years ago on Introduction

    Thank you for the instructable. Another thing you want to be careful of is that when connecting LEDs directly to the pins of the arduino, especially with out resistors, (except pin 13) you will possibly burn our the arduino because it is rated only to put out a certain amount of current. The circuit works but can damage the board.

    0
    apaar dua
    apaar dua

    Reply 5 years ago on Introduction

    Thank you for your concern sir,
    As I have already told that I am biggner in arduino and I still have to learn some basics ,I will take this seriously and next time use resisters.

    0
    skepticaljay
    skepticaljay

    5 years ago on Introduction

    In the code it looks like the green led just blinks on and off every half of a second until the red led comes back on. Why is this?

    0
    apaar dua
    apaar dua

    Reply 5 years ago

    That 'arpind' is a spelling mistake. It is 'around'.

    0
    apaar dua
    apaar dua

    Reply 5 years ago

    The code i designed took arpind 5 days.
    I am a bignner in arduino and i designed the code very carefully as per my skills.
    This answer will also be answered in the video which i will post today.

    0
    gravityisweak

    This could use a lot more photos and some more specific steps. Keep going with it.

    0
    apaar dua
    apaar dua

    Reply 5 years ago on Introduction

    i actually made it today and the photos and the video will be uploaded tommorow