A compilation of the Steel Matrix for Prototyping steel class.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Assignment A- Mig Weld and 90 Degree Fillet
Straight cut and MIG welded to a 90 degree L.
Step 2: Assignment A-Bent Steel Bar
Bent Steel solid tube bar with manual tube bender.
Step 3: Assignment A-Bent Bar 2
Bent Aluminum bar with manual tub bender
Step 4: Assignment A-45 Degree Cut/ Weld/ Grinder
1. Cut 45 degree cuts
2. Mig welded
3. Grinded weld with grinder
4. Sand out welds
Step 5: Assignment A-90 Cuts/drilling/tapping
1. 90 cuts into 2 pieces
2. Line and mark up pieces
3. Drill hole into both pieces
4. Tap only 1 side, manually
5. Clean/ assemble and screw in fastener