Auto Test Pen With Double Function

1,980

28

3

Hello, friends.

Today we are going to do here is a probe car. It has two functions, namely - a show contact with the car body, as well as the presence of a voltage of 12 volts.

Detailed assembly and demonstration work can be seen on the video.


Supplies:

Step 1:

We need

  • Syringe 5 cubes;
  • 4 LR44 batteries;
  • Two LEDs with a resistor;
  • A piece of steel wire;
  • Wire with a clip at the end;

Step 2: Very Simple Scheme

Step 3: Oppositely Connect Two LEDs

Step 4: Solder Resistor, Steel Wire, and Fill It With Hot Glue

Step 5: Bend the Contact and Put Into a Syringe

Step 6: Put the Battery

All is ready.

Detailed assembly and demonstration work can be seen on the video.

Thank you for attention.

Share

    Recommendations

    • Arduino Contest 2019

      Arduino Contest 2019
    • IoT Challenge

      IoT Challenge
    • Classroom Science Contest

      Classroom Science Contest

    3 Discussions

    0
    None
    YouNeverKnowItUntil

    2 years ago

    I like this more than a test light- only works in one direction, uses less energy- but still more dangerous than a multimeter

    0
    None
    DsCloak

    2 years ago

    this clever, i worked on a design for multi-function tester, if i make it post

    1 reply
    0
    None
    ILYANOVDsCloak

    Reply 2 years ago

    Of course make.
    If you make a link to my device - I will be very grateful.