Automatic Starter for Submersible Pump

Introduction: Automatic Starter for Submersible Pump



Normally in all single phase submersible pump we have to press start switch for two second to switch on the pump. and this is so problematic, every time when you switch on pump you have to press this switch, so this the solution i just made monostable circuit which is only on for two second when you switch on then automatically it will switch off, so now i don't have to press this switch every time, circuit will take care about this..

web: www.arshadpthan.com
blog: ars2k6.blogspot.com 

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Tiny Speed Challenge

      Tiny Speed Challenge
    • Clocks Contest

      Clocks Contest
    • PCB Design Challenge

      PCB Design Challenge

    4 Discussions

    0
    ganthade
    ganthade

    2 years ago

    Which triggering input will used and how

    0
    ganthade
    ganthade

    2 years ago

    Plz give a circuit diagram

    0
    Vijendra Rojekar
    Vijendra Rojekar

    4 years ago

    Dear Sir,

    We need following

    1. 120-150 UF, 35 UF + 35 UF Electric Starter How much HP for Submersible Pump.

    2. 120-150 UF, 35 UF + 50 UF Electric Starter How much HP for Submersible Pump.

    3. 120-150 UF, 50 UF + 50 UF Electric Starter How much HP for Submersible Pump.

    Thanks.

    Vijendra Rojekar

    Aurangabad M.S. 431 003