Introduction: Baby Yoda 3d Print Moveable Head
Find the Baby Yoda files.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Slice Head & Add Supports
Step 2: Slice & Add Support
Step 3: Have Size Appropriate Magnets
Step 4: Find Furniture Button Tacks or Ball Bearings
These tacks were left over from a couch we reupholstered. The box had 1200, but we only used 400, so we have plenty left.
Looking today: always check before Buying with a Magnet
Print and Clean up body parts
Drill into your choice of Head or Body and Then Place the Magnet with Hot Glue and then Glue the Tack Head in Place.
Step 7: Hot Glue
Step 8: The Final Set Up
This is an entry in the