Batman Logo- Light Covering

Hello everybody. I'm Marzuk2 . I am going to show you how to make a light covering of a Batman logo. I am sure you will like it. Lets begin our assignment..........

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Things Needed

For this assignment you will need,

1. Paper

2. Pencil and eraser

3. Acrylic/Poster color

4. Brushes

5. Ruler

6. Scissors

7. Super glue

8. Cardboard

Step 2: Begining

First of all , take a paper, pencil and eraser and sketch out the base of the logo. Take the measurement given in the picture. After that cut out the logo.

Step 3: Cardboarding

Put the paper logo on the cardboard and draw out the logo. Cut out the cardboard and you will get the basic part done. After that paint the logo completely black with the help of Acrylic/Poster colors and brushes. On the cardboard write "Batman" with yellow color. But remember do not write Batman while the black paint is wet.

Step 4: Last Step

Finally glue the logo on the light. WALLAH!!!!!! The assignment is complete.

Superheroes and Supervillains Contest

Participated in the
Superheroes and Supervillains Contest

Formlabs Contest

Participated in the
Formlabs Contest

Make it Glow!

Participated in the
Make it Glow!



    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Metal Contest

      Metal Contest
    • Make It Fly Challenge

      Make It Fly Challenge

    2 Discussions


    Reply 4 years ago on Introduction

    Your welcome. And please vote my instructables on the 'Make it glow contest'.