Belt Buckle Cover

1,966

7

1

Published

Introduction: Belt Buckle Cover

About: I like doing anything from cooking to blacksmithing and knotting. Always open for new ideas of things to make.

How to make a cover for a belt buckle with:

Hub cap thingy,
Sheet metal,
Four screws,

Electric drill,
Orbital sander,
Jig saw.

Step 1: Get Cover

I cut out part of a hub cap thing using the jig saw for the cover. Then I cleaned it up.

Step 2: Screws

Drill four holes through cover making sure that the spaces in between screws vertically is large enough for a belt to fit through. Insert screws.

Step 3:

Cut out strips of sheet metal around three or four inches long and about 3/4 wide. Sand down edges so there are no sharp areas or barbs.

Step 4: Assembly

Screw the sheet metal onto the plate with the metal running vertically.

Share

    Recommendations

    • Stick It! Contest

      Stick It! Contest
    • BBQ Showdown Challenge

      BBQ Showdown Challenge
    • Backpack Challenge

      Backpack Challenge

    Discussions