Bike Ramp & Hook

476

1

2

A new method to store bikes in the home. Convenient and fun!

Step 1: Acquire Materials

Step 2: Build Ramp

Cut cardboard to 16 2' by 2' pieces

Stack 2' by 2' cardboard layers and fasten together with bolt

Draw ramp outline ramp

Use Exacto to cut ramp layers based on drawn outline

Cut cardboard to 6 2' by 3""

Stack ramp cardboard layers

Draw support beam outline (approx 1'' by 3'' slit)

Use Exacto to cut 1" by 3" slot across 16 pieces

Step 3: Build Wall Hook

Cut 10 3" by 8" pieces

Stack layers and fasten with bolt

Cut 8 5" by 5" pieces

Stack layers and outline hook

Use Exacto to cut out stacked layers of hooks

Measure width and length of non-curved end of hook

Cut by same width and length into middle of fastened cardboard stack

Step 4: Finishing Touches

Drill screws into stack of hooks

Glue non-curved end into rectangular space

Glue together 3" by 8" cardboard layerstack to make support beam and then glue to in slit on ramp

(Optional) Re-cut ramp so middle is staggered to provide track for bike wheel

Step 5: Secure Hook to Wall

Share

    Recommendations

    • Tape Contest

      Tape Contest
    • Jewelry Challenge

      Jewelry Challenge
    • Trash to Treasure

      Trash to Treasure

    2 Discussions

    0
    None
    seamster

    3 years ago

    This is an interesting idea! What is the purpose of the bottom ramp though?

    1 reply
    0
    None
    Philad3lphiaseamster

    Reply 3 years ago

    I was going to ask you the same question! For fun, I suppose.

    Currently a WIP - V.2 release date is Thursday December 10