Bluetooth-Car With Arduino

About: My name is Alex and I like to do it all with my own hands. I'm fond of arduino and I like to invent different constructions on it.

In this lesson I will show how to make a bluetooth car out of an unnecessary radio-controlled machine.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

- Unnecessary RC car

- Arduiono Uno

- Motor Shield

- Bluetooth module hc-05

- battery +7.2V

Step 2: Installation

First you need to disassemble the car. Remove it from unnecessary (old board, bulb and stuff) you need to leave the motors and the switch. Then, according to the scheme, you need to collect all the electronics and install it on the typewriter. After installing the electronics, you need to collect the car back.At the expense of the circuit, the bluetooth module is connected as follows: Rx - A1 Tx-A0 + 5V power, the motor shield is powered from + 7.2V

Step 3: Sketch

Step 4: App

Arduino Bluetooth RC Car:

Microcontroller Contest 2017

Participated in the
Microcontroller Contest 2017

Be the First to Share


    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest