I apologize for the error, english is not my native language ...
My hobby is making moonshine.
My friend asked for a bit of my product, and i decided to give him a gift box.
- Plywood 4mm
- Any glass bottle...
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Drawing a Drawing for a Laser Cutter
We measure the bottle to understand the dimensions of the box.
This time I decided to make the connection not on the spike, but on the latches.
I had previously created drawings of latches, it remains to add them to the boxes drawing...
Step 2: Cut the Plywood and Collect the Box and Make a Label for the Bottle
We send the drawing to the laser and cut pieces of plywood 4 mm thick.
After, collect the box.
You need to collect carefully, plywood latch can be broken!
A bottle without a label is not beautiful.
I came up with the name and design for my product and sent it to be engraved on 0.6 mm thick veneer.
When everything was ready I smeared the veneer with glue and stuck it to the bottle
Step 3: Put the Bottle in the Box ...
You already have a finished box.
You can see she's bigger than a bottle. If you want it not to hang out, the box needs to be filled. You can use decorative wood shavings.
But I do not have it (
I decided to make a plywood grating filling.
Measure the bottle-draw-collect ...
And... OOPS, does not fit ((((
Again - to measure the bottle-draw-collect ...
This time everything turned out, the bottl is very tight and does not move anywhere)
Step 4: Finish Photo...
It remains to fill the bottle and present to a friend!).