Boy Scout Iphone Case

Introduction: Boy Scout Iphone Case

Step 1: Supplies

1. Old plastic case
2. Old Boy Scout uniform (tattered)
3. Hot glue gun
4. Troop numbers
5. Needle and thread
6. Sharp scissors

Step 2: Prep the Fabric

Take the tattered uniform and cut out a square more than big enough to cover all sides of the case. Center it on the case and tuck it to the inside. Lightly draw a thin line around the top edge of the case. Do the same around the camera hole.

Step 3: Sew Patches

On the inside of the line you drew place the Boy Scouts of America text on the line across from where you put the camera hole. Sew it in place. Place your troop numbers in place below the text. Sew in place. This is the basic design.

Step 4: Apply Cloth

Take the fabric with the patches on it and apply it to the case with hot glue. DO NOT GET GLUE INSIDE THE CASE Carefully apply glue around the side. Trim the border with. The scissors.

Step 5: Impress Your Troop

Be the First to Share

    Recommendations

    • Mason Jar Speed Challenge

      Mason Jar Speed Challenge
    • Pumpkin Challenge

      Pumpkin Challenge
    • Halloween Contest

      Halloween Contest

    2 Discussions

    0
    ericscouter
    ericscouter

    6 years ago

    Yeah I was kind of going for a rugged look I'm sure u could make it look clean

    0
    lukester29
    lukester29

    6 years ago

    I like it but very very sloppy