Branch Chest Without Forstner Bit (update)

About: Find more of what I do on my homepage and on Instagram. But no matter where you go, remember to Be Inspired!

You might have seen the Branch Chest I did a while back, and it required a fairly large forstner (or spade) bit. In order to make this a little less tool dependant, here is a way to do it without a forstner (or spade) bit and use a brad point (or standard) drill bit instead. Enjoy, and remember to be Inspired!



    • Tape Contest

      Tape Contest
    • Trash to Treasure

      Trash to Treasure
    • Arduino Contest 2019

      Arduino Contest 2019

    2 Discussions


    4 years ago on Introduction


    Just a tip: If you add at a nice clear image of your finished project, you'll most likely get a few more views. Full step-by-step instructions will likely get you LOTS more :)

    Great projects though, I'm really enjoying them! Keep up the good work!

    1 reply

    I think you are right. As of now, I usually do not take pictures of the process - I figure I got the camera rolling anyway. But at the very least a proper cover should not be too hard to do. Thanks!